氮氣檢測分析儀 氮氣檢測儀氮含量分析檢測儀
型號：G80545
氮氣檢測儀廣泛用于化肥、石油化工、空分以及生物發酵等工業生產過程中氮氣含量的檢測 .空分制氮、化工流程氮氣純度自動分析，磁性材料等高溫燒結爐的保護性氣體中氮含量分析；電子行業、玻璃、建材行業等工業生產過程中氮氣純度的在線檢測。
一、概述
本儀器是采用測氧原理, 通過氧氣傳感器把氣體中的氧濃度轉換成電信號,經減法器的計算從而倒算出氮氣含量，并直接顯示被測氣體中的氮氣百分比含量。儀表采用*的中大規模集成電路及5位半L E D高亮度數字顯示器，具備數碼撥盤設定下限控制功能，方便快捷。當被監控系統的氮含量低于設定值時,控制觸點啟動，并有聲/光同時報警。儀表還有4-20MA同步信號輸出，并有自動穩零功能，儀器能直接顯示十萬分之一讀數（99.999%），具有響應快、精度高、穩定、可靠、操作簡便等特點。本儀器可利用空氣的氮氣的含量79.0%定標，操作方便，并設有量程自動轉換電路，當?shù)獨鉂舛却笥?0.3%時，這時儀器量程自動轉換，讀數為90.300%。
當?shù)獨鉂舛鹊陀?號下限設定值時（假如是99.96%）,報警指示燈亮，同時有報警聲響，1號報警輸出開關啟動（可當預警提示,或啟動相應的設備）.. 當?shù)獨鉂舛壤^續下降低于2號下限設定值時（假如是99.93%）, 2號報警輸出開關啟動.（可根椐需要啟動相應的控制設備）..這樣更有利于產品質量的生產管理.如果只用1路設定值,那就把2號下限控制數碼撥至90.00即可.2種儀表都帶有4～20mA信號輸出可與記錄儀連接。
本儀器適用于變壓吸附制氮機，空分設備，以及氮氧混合氣中的氮氣濃度分析、監測和控制。
二、產品特點
報警點及觸點輸出任意設置,N2 顯示供用戶選擇,進口新型長壽命的離子流檢測器，靈敏度高、響應速度快,上下限報警點能在全量程范,高精度的溫度自動補償系統，消除環境溫度的影響。
檢測原理：傳感器
監測氣體： 氮氣
三、技術指標：
1.測量范圍 ：70～99.999%
2.精 度： 98～99.999±0.02％N2 ；
3.zui小檢測量： 0.001％
4.響應時間： ≦10秒
5.環境溫度： 0～40℃；
6.環境濕度： ≤85%RH。；
7.電 源： 220V±10％；
8.穩 定 性：48小時內漂移小于±0.2％
9控制點容量：A C220 V 1 A
10.外形尺寸：160×160×80mm（長×寬×高）（開孔尺寸150×75）
11.重 量： 1.2Kg
12.記錄輸出：4～20mA
13.功 耗: ≤5 W
四、原理：
儀器由氧電極、放大器、比較器、減法器,報警器等部分組成。氧電極：為極譜法隔膜式，采用鉑金為陰極，銀氯化銀為陽極，以聚四氟乙稀為滲透隔離膜，氣樣中氧可透過薄膜到達陰極，在650mV的極化電壓下發生如下反應。
陰極：O2+H2O+4e→40H—
陽極：Ag++C1-→AgC1↓+e
反映可迅速達到平衡，同時產生一個極限擴散電流，此電流的大小正比于氣樣中的氧分壓。此電流通過放大器放大，通過減法器由顯示屏直接顯示出被測氣中的氮氣含量，同時輸出4-20電流.供外接記錄儀或微機作數據記錄，可使測量資料存檔。另外信號經撥盤數碼開關控制.，當被測氣體中的氮氣含量超過設定值時，儀器發出聲,光報警.同時啟動相應的控制繼電器動作,以帶動各類控制設備.
關于更多 氮氣檢測分析儀 氮氣檢測儀 氮含量分析檢測儀 詳細請您
Nitrogen gas detection analyzer nitrogen gas detector nitrogen content analysis detector
Model: G80545
Nitrogen gas detector is widely used in fertilizer, oil, chemical, air separation and biological fermentation nitrogen content in the process of industrial production, such as testing, empty on nitrogen, nitrogen purity automatic analysis in chemical plant, magnetic materials, such as high temperature sintering furnace protection of nitrogen content in the gas analysis; The electronics industry, glass, building materials industry and other industrial production in the process of nitrogen purity on-line detection.
An overview,
Principle of the instrument is used to measure oxygen, by oxygen sensor converts oxygen concentration in the gas into electrical signals, the calculation of the subtracter and were turned out of the nitrogen content, and directly show the percentage of nitrogen content in the gas being measured. Instrument adopts advanced large scale integrated circuit and five and a half L E D high-brightness digital display, digital dial setting threshold control function, convenient and quick. When the nitrogen content is lower than the set value of the monitoring system, control the contact starts, and sound/light alarm at the same time. Instrument and 4-20 ma synchronous signal output, and has the automatic zero function, the instrument can directly show the one over one hundred thousand reading (99.999%), with fast response, high precision, stable and reliable, easy operation, etc. The instrument can use air of nitrogen content of 79.0% calibration, easy to operate, and is equipped with automatic range switching circuit, when nitrogen concentration is greater than 90.3%, then the instrument range automatic conversion, reading of 90.300%.
When nitrogen concentration is lower than the lower limit value 1 (in this case, 99.96%), alarm indicator, and at the same time with alarm sound, alarm output 1 switch to start (when warnings, or start the corresponding device).. When the concentration of nitrogen gas continues to fall below 2 lower limit value (in this case, 99.93%), 2 alarm output switches on. (may be root tree need to start the corresponding control device).. So more conducive to the production management of product quality. If only 1 set value, then the lower limit control digital dial 2 to 90.00. 2 kinds of instrument with 4 ~ 20 ma output signal can be connected to the recorder.
This instrument is suitable for the pressure swing adsorption nitrogen making machine, air separation equipment, oxygen and nitrogen mixture of nitrogen concentration analysis, monitoring and control.
Second, the product features
Emergency alarm and any contact output Settings, N2 display for the user to choose from, import new long life of the ion flow detector, high sensitivity, fast response speed, upper and lower stations can fan on full range, high precision automatic temperature compensation system, eliminate the influence of ambient temperature.
Detection principle: sensors
Monitoring gas: nitrogen
Three, technical indicators:
1. The measuring range: 70 ~ 99.999%
2. The fine: 98 ~ 99.999 + / - 0.02% N2;
3. The minimum detectable amount: 0.001%
4. Response time: ≦ 10 seconds
5. The ambient temperature: 0 ~ 40 ℃;
6. Environmental humidity: 85% RH or less. ;
7. Electrical source: 220 v + 10%;
8. Stability: drift within 48 hours of less than 0.2% plus or minus
9 points of control capacity: A C220 V 1 A
10. Overall size: 160 * 160 * 160 mm (length x width x height) (hole size 150 x 75)
11. Weight: 1.2 Kg
12. Record output: 4 ~ 20 ma
13. Power consumption: 5 W or less
Four, the principle of:
Instrument by oxygen electrode, amplifier, comparator, subtracter, alarm and other parts. Oxygen electrode: as polarography diaphragm type, using platinum as the cathode, silver and silver chloride as the anode, ptfe to penetration for isolation membrane, oxygen in the gas sample can be through the membrane to the cathode, the following reaction under polarization voltage of 650 mv.
Cathode: O2 + H2O + 4 e - 40 h -
Anode: Ag++ C1 - - > AgC1 left + e
Reflection can rapidly balance, at the same time produce a limiting diffusion current, the current is proportional to the size of the oxygen partial pressure in the gas sample. This current through the amplifier amplification, the subtracter shows measured directly by the display of nitrogen content in gas, 4-20 current output at the same time. For external recorder or microcomputer for data records, can make the measurement data archive. Signal by the digital dial switch control. Additionally, when measured in the gas nitrogen content is more than the set value, instrument issued sound, light alarm. Start the corresponding control relay action at the same time, to drive all kinds of control equipment.
For more nitrogen to detect the contents of nitrogen analyzer nitrogen gas detector detector please inquire detailed analysis
