美國2B Model 202紫外吸收法臭氧分析儀
北京中清國投環?？萍加邢薰?品質 一站式采購 美國2B Model 202 紫外法臭氧分析儀大量現貨供應！咨詢！
美國2B Model202紫外吸收法高精度臭氧分析儀（1.5ppb-250ppm）
美國2B Model 202紫外吸收法臭氧分析儀簡介：
美國2B公司的Model 202臭氧分析儀基于成熟的紫外吸收技術@254nm，使測量更加精確，測量范圍1ppb至100,000ppb(0-100 ppm) 。相對常規儀器，Model 202臭氧分析儀重量輕（2.1 kg），能耗低(12V DC， 0.33 amp，4.0 Watt)，因此適合應用于如下場合：
高空測量垂直分布、遙控飛行器RPVS及輕型飛機等場合，在那里對空間及重量有嚴格限制。
需長期檢測的偏遠地區，用電受嚴格限制。
市區地面基站探測網
個人暴露測量，用于環境污染對健康影響的研究
環境健康及安全監測
實驗室研究，研究材料和組織暴露于臭氧的影響
The 2B Technologies Model 202 Ozone Monitor? is designed to enable accurate and precise measurements of ozone ranging from low ppb (precision of ~1 ppb) up to 250,000 ppb (0-250 ppm) based on the well-established technique of absorption of UV light at 254 nm. The Model 202 Ozone Monitor? is lightweight (4.7 lb., 2.1 kg.) and has a low power consumption (12V DC, 0.33 amp, 5 watt) relative to conventional instruments and is therefore well suited for applications such as:
Vertical profiling using balloons, kites, RPVs and light aircraft where space and weight are highly limited
Long-term monitoring at remote locations where power is highly limited
Urban arrays of ground-based detectors
Personal exposure monitoring for studies of health effects of air pollutants
Environmental health and safety monitoring
Laboratory studies of the effects of ozone exposure on materials and organisms
特點：
Model 202臭氧分析儀被EPA認定為等效測量方法（Federal Equivalent Method /FEM：EQOA-0410-190）。作為的FEM，該儀器可廣泛用于各個州和其它檢測機構，遵循大氣質量監督40 CFR 58 節，符合潔凈空氣法則檢測標準。
車載電源適配器可用于運動中/野外大氣化學研究
可輸入三個模擬信號用于科學研究
溫度、濕度和海拔高度修正(海拔升高1000米產生的誤差高達14%!)，隨時隨地確保
讀數精確；Dew-Line濕度修正技術克服了傳統紫外臭氧分析儀的限制，使得濕度
對臭氧測量的干擾從高達近百個ppb降低到可以接受的幾個ppb的水平
技術參數
| 檢測原理 | 254nm的紫外吸收技術 |
| 檢測范圍 | 1.5 ppb to 250 ppm; |
| 精度 | 0.1ppb |
| 誤差(1σ; rms noise) | 1.5ppb或者讀數的2% |
| 臨界值 | 3.0 ppb |
| NIST可追蹤校準 | 有 |
| 測量區間 | 10秒（平均數據選項：10秒，1分鐘，5分鐘，1小時） |
| 流量 | 1升/分鐘 |
| 流量需求 | > 0.6升/分鐘 |
| 基線漂移 | <2 ppb/天 <5 ppb/年 |
| 靈敏度漂移 | <1%/天 <3%/年 |
| 測量時間，頻率 | 10秒，0.1赫茲 |
| 響應時間 | 20秒 |
| 平均時間 | 10秒，1分鐘，5分鐘，1小時 |
| 數據存儲 | 14,336 lines (10 s avg. = 1.4 days; 5 min avg = 1.4 mo.) |
| 臭氧單位 | ppb的，ppm時，pphm，微克米-3米-3毫克 |
| 重量 | 4.7磅（2.1公斤）;1.6磅（0.7公斤） |
標準配置
·臭氧監測Model202主機
·交流電源適配器（100-240 VAC至12伏直流電具體國家的插頭）
·蓄電池導線連接器
·歸零墨盒
·操作手冊光盤
·校準數據和NIST可追蹤校準證書
·儀器出生證明書
·一年保修
Specifications
| Measurement Principle | UV Absorption at 254 nm |
| Federal Equivalent Method (FEM) | Yes, EQOA-0410-190 |
| Linear Dynamic Range | 0 to 250 ppm |
| Resolution | 0.1 ppb |
| Precision (1σ; rms noise) | Greater of 1.5 ppb or 2% of reading |
| Accuracy | Greater of 1.5 ppb or 2% of reading |
| Limit of Detection (2σ) | 3.0 ppb |
| NIST-Traceable Calibration | Yes |
| Measurement Interval | 10 s (Data averaging options: 1 min, 5 min, 1 hr) |
| Flow Rate (nominal) | ~1 Liter/min |
| Flow Rate Requirement | >0.6 L/min |
| Baseline Drift | <2 ppb/day <5 ppb/year |
| Sensitivity Drift | <1%/day <3%/year |
| Measurement Time, Frequency | 10 s, 0.1 Hz |
| Response Time, 99% of Step Change | 20 s, 2 points |
| Averaging Times | 1 min, 5 min, 1 hr |
| Internal Data Logger Capacity | 16,383 lines (10-s meas. = 1.9 days; 1-min avg = 11 days; 5-min avg = 1.9 mo; 1-hr avg = 1.9 yr) |
| SD Card Logger Capacity | Minimum 2 GB (> 5-year capacity for 10-s measurement mode) |
| Ozone Units | ppb, ppm, pphm, ?g m-3, mg m-3 |
| Pressure Units | mbar, torr |
| Temperature Units | °C, K |
| T and P Corrected | Yes |
| Operating Temperature Range | 0 to 50 °C standard; optional -20 to 50 °C with low temperature modifications (pump and lamp heater cold-weather package) |
| Operating Altitude Range | ~0-13.5 km (150-1,013 mbar) standard; optional ~0-25 km (30-1,013 mbar) with upgraded pressure sensor |
| Power Requirement; Supplied by battery or 110/220 VAC Power Pack | 12 V dc or 120/240 V ac, 470 mA, 5 watt (4 watt with cell heater unplugged) |
| Size | 3.5 x 8.5 x 11 inches (9 x 21 x 29 cm) |
| Weight | 5.3 lb (2.4 kg); 2.6 lb (1.2 kg) without instrument case |
| Analog Inputs for Internal Logging of Other Instruments | 3 Analog Inputs, 0-2.5 V; For example could log external T, P and RH |
| Data Outputs | RS232, 0-2.5 V Analog, LCD Display: (Optional 4-20 mA Current, External USB Converter; request quote) |
| Data Transfer Baud Rates | 2400, 4800, 19200 |
| Output Ranges | User-Defined Scaling Factor in Menu |
| DewLine? | Yes |
| Backup Air Pump | Yes |
| Flow Meter | Yes |
| Options | Battery; External Particle Filter; Serial-to-USB Converter; GPS; Bluetooth; 4-20 mA Current Output; Cold-Weather Package (pump, lamp heater); High-Altitude Upgrade; Long-Life Internal Air Pump; Rack-Mount Case Configuration |
| Upgradable to Model 205 Dual Beam | Yes |
